TopTank eVod
Specs:
- Capacity: 1.7mls
- 510 Threading
To fill your tank:
1. Unscrew the top.
2. Fill V-Lixir down the sides of the tube, and fill to just under the lip of the center barrel (avoid getting any liquid down the hole in the center).
3. Reattach the top, and vape away :-)
NOTE: Be sure to not let it run too dry before refilling as that could lead to a burnt taste.
Changing your Atomizer:
The lifespan of your atomizer coils will depend on your usage and vaping habits. This could be anywhere from 5 days to a few weeks. When the atomizer coil wears down, it may begin to leak, taste burnt or be hard to draw from.
To change your atomizer coil:
1. Hold the tank upside down.
2. Unthread the metal base from the tank, and set the tank aside.
3. Unthread the atomizer coil from the metal base, and discard.
4. Thread the new atomizer into the metal base, and then thread the base back onto the tank.
5. Before using, we recommend priming the atomizer by taking a few "dry draws". To do this simply take a few draws off your e-cig without pressing the button. This circulates the v-lixir throughout the coils and helps prevent your atomizer from burning out prematurely.
eVod Battery
Specs:
- 650mAh
- Output: 3.7 Volts
- 510 Threading
Locking/Unlocking your Battery:
Your battery will come to you locked. This features protects your e-cigarette from unwanted use when being stored in a purse or pocket, for instance. We encourage you to store your e-cig in a protective lanyard or carrying case. To lock or unlock your battery, simply press the activation button of your battery 5 times fast.
Charging your Battery:
Your battery will typically come 50% charged. We recommend using your battery until it is fully drained (dead) before charging it the first time. Normally, your battery will only take a few hours to fully charge; we suggest allowing it to charge for a full 8 hours the first time.
To charge your battery, simply remove the tank from your battery. Then screw the battery onto the designated USB charger. The light on your charger will turn red when the battery is low or dead, and turn green once fully charged.
Short Circuit Protection:
If there is a short in your heating element, your LED light may blink multiple times and the battery may shut down. To reactivate your battery, plug it into your charger (and change your atomizer).
Overcharge Protection:
Once charged, your battery will cut itself off in order to prevent being overcharged.
10 Second Cut-Off:
If your activation button is held down for more than 10 seconds the battery will cut-off to prevent your atomizer from burning out.